Serving Richardson and Richardson and south Collin County since 2008
Licensed & InsuredFree EstimatesMon-Fri 8am-6pm
(972) 480-3656 Licensed & Insured
Book a Free Foundation Inspection
Concrete Leveling and Slab Jacking in Richardson, TX

Concrete Leveling and Slab Jacking in Richardson, TX

Richardson Superior Foundation Repair offers professional concrete leveling and slab jacking in Richardson, TX for sunken driveways, patios, sidewalks, garage floors and pool decks. We lift with polyurethane foam injected through 5/8-inch holes, fill the voids that let the slab sink and seal the joints afterward. Most jobs take a few hours and run $650 to $1,800.

Concrete flatwork sinks for the same reasons houses do: the clay under it shrinks, or water washes the fill out from underneath. Lifting it costs a fraction of tearing it out and repouring, and you can drive on it in 15 to 30 minutes. We'll also tell you when a slab is too broken to save.

Get a FREE Estimate

Or call (972) 480-3656

  • Polyurethane foam, not mudjack slurry: 2 to 4 pounds per cubic foot
  • 5/8-inch holes instead of 1.5- to 2-inch ones
  • Back in use in 15 to 30 minutes
  • 5-year workmanship warranty on every lift

Concrete Leveling Applications

If it's flat concrete on the ground and it's sunk, we can usually lift it. These are the jobs we do most.

Driveway Concrete Leveling

Driveway Concrete Leveling

Driveway panels sink at the garage apron and along the edges, where downspouts and sprinklers wash out the fill. We lift each panel back in line with its neighbors and fill the void underneath so it doesn't drop again.

Patio and Pool Deck Leveling

Patio and Pool Deck Leveling

A patio that tilts toward the house sends rainwater straight at the slab, so lifting it back is a foundation fix as much as a patio fix. Pool decks get lifted slowly around the coping so nothing cracks.

Sidewalk and Walkway Leveling

Sidewalk and Walkway Leveling

A sunken walkway panel with a raised edge is a trip hazard waiting for a guest. We lift it flush with the panels on either side and seal the joint so it stays there.

Garage Floor Leveling

Garage Floor Leveling

Garage slabs crack and sink near the door and along the edges. Lifting closes the step at the door and stops water from running back under the slab every time it rains.

Porch and Step Leveling

Porch and Step Leveling

Front porches and steps that pull away from the house leave a gap that collects water right against the grade beam. We lift them back and seal the gap.

Slab Void Filling

Slab Void Filling

Sometimes a slab hasn't dropped yet, but it sounds hollow when you tap it. Injecting foam into the void stops it before it cracks.

Polyurethane Concrete Leveling vs Mudjacking

Mudjacking pumps a cement and sand slurry under the slab through 1.5- to 2-inch holes. That slurry weighs 100-plus pounds per cubic foot, which adds load to the same clay that let the slab sink in the first place.

Polyurethane weighs 2 to 4 pounds per cubic foot and goes in through 5/8-inch holes. It doesn't wash out, it cures fast and you can drive on it in 15 to 30 minutes. That's why it's the only method we use.

Cured foam doesn't shrink, crumble or soak up water, so the void stays filled when the clay dries out again next summer. Slurry can crack and wash away over time, which is why mudjacked panels often drop a second time.

It does cost more per pound than slurry. On a typical driveway, patio or walkway job, ours runs $650 to $1,800.

When Slab Jacking Isn't the Answer

Slab jacking lifts concrete. It doesn't glue broken concrete back together. If a panel has shattered into pieces or a tree root has heaved it, replacing that panel is the better use of your money.

We also won't use foam under a house foundation. A house needs piers bearing on firm ground, pressed to refusal at 8 to 18 feet on most of our jobs. Foam under a grade beam is a short-term patch on a long-term problem.

And if the slab is sound but the soil under it keeps washing out, drainage comes first. We'll tell you when a French drain or a downspout line needs to go in before the foam, or the panel will just sink again.

Why Flatwork Sinks and How We Keep It Up

Clay shrinks under concrete in a dry summer, and the slab follows it down. Downspouts and sprinkler heads aimed at a driveway edge wash fill out from below, a little more with every storm.

After the lift we seal the joints with flexible sealant so water can't get under the slab again, and we point out any downspout or sprinkler that's causing the washout. Moving a downspout to discharge at least 5 feet from the concrete often matters as much as the lift.

Pool decks have one more cause. A slow leak in the pool plumbing or an auto-fill that runs constantly can keep the soil under one side wet. If a deck keeps dropping at the same corner, we'll suggest a leak check before the lift.

Concrete leveling carries a 5-year workmanship warranty. If a panel we lifted settles, we come back and lift it again.

What to Expect on Concrete Leveling Day

Most jobs take a few hours and wrap up the same day. We drill 5/8-inch holes, inject the foam in stages and watch the panel rise against a string line so it lands flush with its neighbors.

The day before, we'll ask you to move cars off the driveway and shut off the sprinklers near the work, so the soil isn't soaked when we inject.

Then we patch the holes with cement, seal the joints and clean up. You can walk on it right away and drive on it in 15 to 30 minutes.

You'll get a written price within 1 business day of our visit, and nothing is due until the panels are up and the joints are sealed.

Lift It Before You Tear It Out

Call (972) 480-3656 for a free estimate on concrete leveling. We'll check whether your slab can be lifted and give you a written price within 1 business day.